Enphase 'Device produced no power': what it means and what to do

One or more of your devices, normally microinverters under the panels, has not produced power. It can be harmless, such as low light, snow, or a utility outage, or it can point to a communication problem or a faulty microinverter. It is not an emergency, but check it soon. Look at the app and the gateway lights, and call for service if it continues.

Fix soon

How common is this fault?

  • We have seen this fault on 519 Enphase systems, 10.4% of the 4,999 Enphase systems we monitor (last 12 months, as of November 2026).
  • Once it appears, the system usually clears it in about 173.8 hours (median), and 0% clear within 24 hours.
  • Source: Otovo fleet monitoring and service records, data as of November 2026.

What causes this fault?

  • Low light at dawn or dusk, or panels covered by snow or heavily shaded. Enphase says microinverters need enough sunlight to power up.
  • A utility power outage or unstable grid, which makes microinverters stop producing until the grid recovers.
  • A solar breaker that is off or tripped.
  • The microinverter cannot communicate with the gateway over the power lines, so the app shows no power for it.
  • A microinverter, panel or connection fault that a technician must test.

What can I safely try myself?

  1. Open the Enphase App Note which devices are affected, the alert text and the time it appeared.
  2. Think about light and weather Look from the ground for snow, leaves or new shade over the panels. If it is early morning, evening or night, it can be normal. Do not go on the roof.
  3. Read the gateway's lights On Enphase gateways the Power production light is solid green when all communicating microinverters are producing. Solid amber (red on newer gateways) means at least one is not producing, and it is off when they are not communicating, for example at low light or night.
  4. Check the solar breakers are on Enphase says that after a power outage you should verify that the breakers for the solar array are on at the electrical panel. If one has tripped, do not keep resetting it: leave it off and call a professional.
  5. Wait after a power outage Enphase says production resumes when the utility restores power, and that the microinverter can stay off for about five minutes after the grid recovers.

When should I call a professional?

Call a professional if the same device is still not producing in good daylight after these checks, if a breaker trips again, or if the Power production light stays amber or red for more than a day. Otovo services these systems and can diagnose this fault. Never open panels, microinverters or enclosures.

Frequently asked questions

Is this dangerous?
The alert itself is not a danger. Do not touch wiring or equipment. If you notice a burning smell or damage, switch the solar breaker off and call a professional.
Why can it be normal at night?
Microinverters are powered by the panels. Enphase says the Power production light is off when microinverters are not communicating at low light or night.
Can I repair a microinverter?
No. Enphase states microinverters contain no user-serviceable parts.
Is this the same as a gateway that is not reporting?
No, but the two can look alike in the app. If the gateway is not reporting, check that first: see the guide on the Enphase gateway not reporting.

Plain text version